4 Point Jack Adapter for Axle, Transmission, Transfer case, Fuel Tank, Bumper - Floor & Transmission Jack Bases

The 4-Point Jack Adapter offers the versatility to lift just about anything that is large, heavy, and awkward with your jack. Easily converts most jacks to safely hold a solid axle, 3rd member, driveshaft, transfer case, transmission, bumper, fuel tank, etc... Modular design allows easy configuration for different parts. It has threaded supports all around and includes a wrench to make adjustments with weight on it. It has a 3/8" thick base plate with 1/2" bolts which hold the U-slot bars. This design makes it easy to center the jack under the load, then move the supports to find pick points. Threaded supports are 8" long 3/4" dia. all-thread that can be replaced with custom lengths.We went all the way back to the drawing board for the new 4-point Jack Adapter. Our 1½" adapter pin that replaces the floor jack saddle allowed for the new design that allows you to use 911 Motorsports Floor Jack Extensions. For transmission jacks the base adapter uses two 3/8" mounting bolts (need to drill your jack plate to mount) and two pins that locate the 4 pt. Jack Adapter to keep it from spinning.

• Jack **NOT** included. Floor Jack option includes bolt-on Adapter Pin that replaces the 24mm fine thread saddle mount on most 2+ Ton floor jacks. Confirm your saddle mount style before ordering. Transmission Jack option includes adapter that requires two 3/8" holes drilled through jack plate.
• Offers the versatility to lift parts that are large, heavy, and awkward with your transmission or floor jack. Check out the "911 Motorsports Floor Jack Extension" that fits on the Adapter Pin and makes your jack even more versatile.
• Minimum height is 6", Max height is 12" above jack base. Top bars adjust from 7-28” wide. Bottom bars adjust from 6-25” wide. Comes with wrench for adjusting threaded supports and tightening bars.
• 800 lbs. capacity at maximum extension
• Made in USA